ThingMagic Mercury API v1.23.0 - Manual (Page 50)

Advanced Tag Operations
50 Level 2 API
Gen2.NXP.G2I.EasAlarm and Gen2.NXP.G2X.EasAlarm
sets or resets the EAS system bit. When set, the tag will return an alarm code if an “EAS
Alarm” command is received.
The response to the EAS Alarm command contains 8 bytes of EAS Alarm Data
Note
Cannot be used through Embedded TagOp Invocation , only via Direct Invocation
and it does not support TagFilter Interface usage.
Gen2.NXP.G2I.Calibrate and Gen2.NXP.G2X.Calibrate
Calibrate causes the tag to return a random data pattern that is useful in some frequency
spectrum measurements.
Note
Calibrate can only be sent when the tag is in the Secured state, when the
access password is non-zero.
Gen2.NXP.G2I.ChangeConfig
Used to toggle the bits of the G2i* tag’s Gen2.ConfigWord. Specify ‘true’ for each field of
the
Gen2.NXP.G2I.ConfigWord to toggle that setting.
Different version of the G2i* tags support different features. See tag data sheet for
specific bits supported.
The Gen2.NXP.G2I.ChangeConfig command can ONLY be sent in the Secured state, i.e.
requires a non- zero password. Caution should be used when using this through an
Embedded TagOp Invocation . Since this command toggles the specified fields, if the tag
responds twice (or an even number of times) during an inventory round the end result will
be no change.
Gen2 Tag Specific TagOps - Impinj Monza4
The following tag operations are custom tag commands supported only on tags using
Impinj Monza4 and Monza5 chips. These operations are supported by readers of type
SerialReader and the M6.