ThingMagic Mercury API v1.23.0 - Manual (Page 49)

Advanced Tag Operations
Level 2 API 49
Gen2.Alien.Higgs3.LoadImage
This command writes Reserved, EPC and User Memory to the Higgs3 tags in a single
command, thereby reducing the tag programming time compared to the use of multiple
Gen2.WriteData commands.
Gen2.Alien.Higgs3.BlockReadLock
This command allows four-word blocks of User Memory to be read locked. Once read
locked the correct Access Password will be required to read the contents of the locked
blocks with Gen2.ReadData.
Gen2 Tag Specific TagOps - NXP G2*
The following tag operations are custom tag commands supported only on tags using
NXP G2xL, G2iL and/or G2iM chips. The commands are supported on all chip types as
their names imply. These operations are currently only supported by readers of type
SerialReader and the M6.
Gen2.NXP.G2I.SetReadProtect and
Gen2.NXP.G2X.SetReadProtect
Causes all tag access command, all Gen2 TagOps and Gen2.NxpSetReadProtect,
Gen2.NxpChangeEAS, Gen2.NxpEASAlarm and Gen2.NxpCalibrate to be disabled until
a
Gen2.NXP.G2I.ResetReadProtect and Gen2.NXP.G2X.ResetReadProtect is sent.
Gen2.NXP.G2I.ResetReadProtect and
Gen2.NXP.G2X.ResetReadProtect
Restores normal operation to a tag which is in ReadProtect mode due to receiving
Gen2.NXP.G2I.SetReadProtect and Gen2.NXP.G2X.SetReadProtect .
Note
Gen2.NXP.G2X.ResetReadProtect cannot be used through Embedded TagOp
Invocation , only via Direct Invocation . However the G2I version can and can be
used with G2x tags.
Gen2.NXP.G2I.ChangeEas and Gen2.NXP.G2X.ChangeEas
Sets or resets the EAS system bit. When set, the tag will return an alarm code if an “EAS
Alarm” command is received.