Losi LOSB9810 - Manual (Page 2)

4. Connect the RED plug with your charger.
5. If you’re using the LOSB9605 balance charger, you should also connect the
balance plug to the charger.
6. Do not leave the battery unattended while charging.
7. With your LiPo transmitter battery pack properly charged, you are ready for
installation.
Installation of LOSB9810:
1. Using your radio manufacturer’s instructions, remove your current transmitter
battery.
2. Examine and note the polarity of the Transmitter Power Connector (refer to
the manufacturer’s manual).
3. Looking at the transmitter battery, notice that the RED wire is the Positive
lead and the BLACK wire is the Negative lead on the connector.
Please see picture below of a JR Z1 (KoPropo Helios) transmitter.
With the LOSB9810 transmitter battery in hand, plug the battery connector into
the transmitter connector.
Note: The connector Pin is nearest the marked plus (+) sign and
is positive; the center Pin is Negative (-). You may want to mark
your transmitter as shown for easy reference when removing and
installing the battery.