Losi LOSB0236BD - Manual (Page 4)

Safety Precautions
Age Recommendation: 14 years or over. This is not a toy. This product is not
intended for use by children without direct adult supervision.
This is a sophisticated radio controlled model that must be operated with caution and common
sense. Failure to operate your Micro Rock Crawler in a safe and responsible manner could
result in damage to the model and property. The Micro Rock Crawler is not intended for use by
children without direct adult supervision. Losi and Horizon Hobby shall not be liable for any loss
or damages, whether direct, indirect, special, incidental, or consequential, arising from the use,
misuse, or abuse of this product or any product required to operate it.
• This model is controlled by a radio signal subject to interference from many sources
outside your control. This interference may cause momentary loss of control, so it is
advisable to always keep some distance in all directions around your model as a safety
margin to avoid collisions.
• Always operate your model in an open area away from cars, traffic and people.
• Avoid running your model in the street where damage can occur.
• Never run your Micro Rock Crawler with low transmitter batteries.
• Carefully follow the directions and warnings for this and any optional support equipment.
• Keep all chemicals, small parts and anything electrical out of the reach of children .
Tools and Items You Will Find Handy
• Soft bristle brush for cleaning
• 1.5mm Allen Wrench (LOSA99105)
• 2mm Allen Wrench (LOSA99106)
• .050-inch Allen Wrench (LOSA99100)
• Losi Micro Screwdriver - LOSB1602
Note: Use only Losi tools or other high-quality tools. Use of
inexpensive tools can cause damage to the small screws and parts used on
this type of model.
The Radio System
The following is an overview of the various functions and adjustments found on the Micro Rock
Crawler radio system. Since the Micro Rock Crawler operates on a radio signal you control, it
is important for you to read and understand about all of these functions and adjustments before
driving.
The ESC/Receiver
1. On/Off Switch: Powers the receiver
and ESC.
2. Bind Button: Used to “bind” the
receiver to the transmitter.
3. Steering Port: Where the steering
servo(s) plugs in (note wire
connection order).
4. Motor Lead: Connects to the wire
leads from the motor.
5. Indicator Light: Shows that a
frequency/channel is being received.
6. Battery Lead: Connects to the battery
pack for power.
4
4
1
2 3
Orange
Red
Brown
5
6