Losi LOSB0236BD - Manual (Page 3)

3
Charger
1. Your Losi Micro Rock Crawler includes a complete
set of batteries for the portable charger.
2. Remove the battery cover by sliding it in the
direction noted on the cover. Install (8) AA alkaline
batteries into the bottom of the charger. Pay close
attention to the correct direction of the positive
(+) and negative(-) ends as marked. Reinstall the
battery cover.
3. Plug the battery lead into the charger lead. The
RED LED will light up and stay solid while charging.
When the battery is fully charged the light will shut off
(approximately 20 minutes). If the charger light only
lights up for about a minute, the AA batteries inside
the charger are low and should be replaced.
4. Plug in the battery lead into the speed controller
lead and replace the body.
5. While pressing the white “Bind” button, slide the
switch to the “On” position. When the green LED
begins to flash rapidily release the bind button.
6. Switch on the transmitter and you should notice
a blinking LED on the back of the transmitter with a
translucent cover (MTX-Pro or LSR-3000). NOTE:
If using other Spektrum transmitters, please consult
your instruction manual for help with this process.
7. Once the transmitter has been bound with the Micro Rock Crawler on, if the wheels spin, adjust the “TH.
Trim” on your transmitter until they stop. To go forward pull the trigger back. If you should need to reverse,
push the trigger forward. When going forward the model should move in a straight line. If not, adjust the “ST.
Trim” so that it tracks in a straight line without having to turn the steering wheel. After you are finished run-
ning, turn the Losi Micro Rock Crawler off FIRST by sliding the switch to the “Off” position. After the model
has been turned off, turn off the transmitter.
Spektrum DX2, DX3 and radios equipped with Spektrum modules
are also compatible with Bind-N-Drive
Getting Started