Hollywood Racks F2 Spoiler User Manual

Page 3

Fig. 15a

h) Attach the hooks on the lower straps to the
bottom of the trunk or hatch lid and pull snug.
See Fig. 15a.
Note that the lower strap

‘s buckle can be

relocated to the higher hole on the main
frame if required. Use the 10mm wrench
included with the rack. Recheck all straps
to make sure they are snug.

i) Unlock the center hubs and rotate the support
arms so they are horizontal or pointing slightly
upwards, then lock hubs. See Fig. 15b.

f) Depending on the height of the vehicle, you may not
be able to rotate the clearance frame high enough
above the spoiler for a correct “strap angle” (Fig. 12).
In that case, you can re-locate the upper buckles to get
the correct strap angle. There are additional buckle
hole positions located on the spoiler clearance frame.
Use the 10mm wrench included with the rack (or
equivalent) to relocate the buckles if necessary.
See Fig. 13

Fig. 14

Fig.11

g) Attach the hooks to the hatch lid and pull the
strap end snug. See Fig. 14. Lower pads should
remain seated against bumper.
bumper. See Fig. 11b

The strap angle from the upper-most buckles to
the upper hooks must be high enough so that
the straps are not making any contact with the
spoiler!

Fig. 12

Fig. 13

Fig 15b