Hollywood Racks HR1000 SportRider 2 bike version 1 - Manual (Page 2)

6. continued: When all the nuts and bolts are tight, press the black plastic nut caps
(g. and h.) on to the exposed nuts and bolts on the rack. These are a simple press
fit, and should snap into place with a minimal application of force.
Fitting the Hollywood Sport Rider to your vehicle:
7. Now that the basic rack is assembled, it’s time to fit the rack to your vehicle.
If your vehicle has a 2” receiver
, simply insert the insert tube (2.) of the rack into
the receiver of your vehicle. If your vehicle has a 1-1/4 receiver, proceed directly
to instructions 9. / 10. Line up the large hole at the end of the insert tube with the
hitch bolt hole in your receiver.
8. Take the large bolt (b.) with ¾” head (threaded hitch bolt), and slide on first the
lock washer (d.), and then the large
flat washer (c.) See Fig. 5. When the
washers are installed, install the
threaded hitch bolt through the hitch
bolt hole in your receiver, then thread
it into the insert tube of the rack.
Tighten securely.
Instructions for vehicles with
1-1/4” receiver:
9. If your vehicle has a 1-1/4”
receiver, you will need a Phillips
head screwdriver to remove the 2”
spacer first. The spacer is the black
U-Shaped plastic piece attached to
the end of the insert tube (2.). Simply
unscrew the Phillips head screw that
is holding the spacer to the end of the
insert tube.
Fig 3.
Knob to
raise and
lower
vertical
tube.
Fig 5.
Fig 4.