Hollywood Racks T900 Truck Rack - Manual (Page 2)

Attaching Load Bar to Clamps
Loosen thumbscrew and adjust length of the load bar
to fit over top holes of the Grip Rite clamps.
Note: Trucks with inner rails must use inside holes
of the angle bracket, trucks with outer rails must use
outside holes of angle bracket.
Remove and re-insert top bolts through proper
angle bracket holes and into Grip Rite clamps
as indicated. The angle brackets must be resting
on top of the truck bed side wall (bottom of angle
brackets are padded). Tighten top AND center bolts
securely using the Allen wrench provided.
(3) Attaching Bicycles to Load Bar
Position ford mounts approximately 12” inside truck
bed side walls in upright position. Tighten bolts
securely
using Allen wrench provided.
Remove front wheel from bicycle and place front fork mount onto fork mount axle. Adjust and
tighten quick release skewer. Optional front wheel holders (part #916) are available.
(4) Removing Rack from Truck
The rack can be removed with either the Grip-Rite clamps remaining attached to the truck bed
(simply remove top bolts), or with the clamps remaining attached to the rack (remove center
bolts).
Limited Lifetime Warranty (effective January 1, 2008):
Hollywood Racks will warrant its car racks and accessories during the time that an original retail purchaser owns the
product subject to the exclusions and limitations of this warranty. Hollywood Racks will remedy defects in materials and
workmanship by repairing or replacing (at its option) a defective part or the complete rack without charge for labor or
parts. Hollywood Racks may elect (at its option) to issue a refund equal to the purchase price paid for the product.
This warranty does not cover problems caused by normal wear and tear including (but not limited to) weather,
scratches, dents, rust, accidents, unlawful vehicle operation, misuse, abuse, neglect, theft, unauthorized modifications,
or unauthorized repair. No warranty is given for defects resulting in incorrect assembly, incorrect installation onto the
vehicle, installation on a “no fit” vehicle, incorrect attachment of bicycles onto the rack, or overloading of the rack’s
weight restrictions. This warranty terminates if the original retail purchaser transfers the product to any other person.
If a product is believed to be defective, the original retail purchaser should contact either the original retailer or
Hollywood Racks directly at 800-747-4085 or at [email protected]
Disclaimer of Liability: Repair or replacement of a defective product or the issuance of a refund or credit (as
determined by Hollywood Racks) is a purchaser’s exclusive remedy under this warranty. Damage to a purchaser’s
vehicle, cargo, bicycles and or to any other person is excluded. This warranty is expressly made in lieu of any and all
other express warranties, whether oral or written. Hollywood Racks shall not be liable for any direct, indirect,
consequential, incidental, special, punitive or any other damages in connection with the purchase, use or handling of this
product.
Some states do not allow the exclusion or limitation of consequential or incidental damages and the above
limitation may not apply to you. This warranty gives you specific legal rights and you have other rights,
which vary from state to state.
HOLLYWOOD RACKS 12812 S. Spring Street Los Angeles, CA 90061
800-747-4085 [email protected] www.hollywoodracks.com
Customer Service: 8:00 AM to 3:00 PST Monday – Friday Made in Taiwan 022008 Rev A