Craftsman 919.762350 - Manual (Page 9)

Use clean, fresh, regular unleaded gasoline with a
minimum of 85 octane. Do not mix oil with gasoline. If
unleaded fuel is unavailable leaded fuel may be used.
IMPORTANT: It is important to prevent gum deposits
from forming in essential fuel system parts such as the
carburetor, fuel filter hose or tank during storage. Also,
experience indicates that alcohol-blended fuels (called
gasohol or using ethanol or methanol) can attract
moisture which leads to separation and formation of
acids during storage. Acidic gas can damage the fuel
system of an engine while in storage. To avoid engine
problems, the fuel system should be emptied before
storage of 30 days or longer. Never use engine or
carburetor cleaner products in the fuel tank or perma­
nent damage may occur.
NOTE: Never start pressure washer without water
source turned on and connected to pressure washer.
To Start Your Pressure Washer
• Remove gas cap
• Add unleaded gasoline, slowly, to fuel tank.
• Do not overfill.
Connect garden hose to the water Inlet on the
pressure washer. Tighten by turning water inlet
counter clockwise.
Connect high pressure hose to discharge on pump.
Connect the garden hose to the waterspout
and turn water supply on.
Squeeze trigger on pressure washer wand to relieve
air pressure caused by turning on the water. Water
win spew out of the gun in a thin stream. This will
make it easier to start the engine.
Engage the safety latch on the spray gun. This locks
the trigger in place and keeps you from accidentally
spraying a high pressure stream.
SAFETY
LATCH
• On the engine there is a choke/run lever. Place lever
to the choke position.
• On the engine there is a throttle control lever. Place
throttle to the rabbit position. Always start engine
with throttle in the rabbit (high speed) position.
• Grasp the starter grip and pull slowly until resistance
is felt;, then pull firmly to start engine.
NOTE: If engine does not start right away, squeeze
the trigger on the gun to relieve water pressure
caused by turning on the water. Water will spew
out of the gun in a thin stream. This will make it
easier to pull start the engine. If more than five
pulls are required, place choke lever back to run
position.
• When engine starts, gradually move choke lever to
RUN position.
• For hot engine restarts, make sure throttle is in the
rabbit (High speed) position and the choke lever is in
the RUN position.
• Grasp the starter grip and pull slowly until resistance
is felt; then pull firmly to start engine.