Craftsman 919.762350 - Manual (Page 11)

After using the pressure washer, you should flush
the pump, chemical injector and chemical line with clear water. To do so, simply place chemical injector
hose in water and siphon for 1 to 2 minutes.
MAINTENANCE
CUSTOMER RESPONSiaUTIES TABLE
MAINTENANCE TASK
Before each use
Every 25
hours or yearly Every 50
hours or yearly Every 100
hours or yearly
PRESSURE \A№HER
Check/dean Inlet screen. X
Check high pressure hose. X
Check soap and chenricai hose and filter X
Check gun and weux I for leaks. X
Purge pump of air and contaminants X
ENGINE
Check oil level X
Change engine oil X
Service air dearer X
OeaiVrepiace spark plug X
Product Specifications
Pressure Washer Specifications
Pressure 2350
Flow Rate 2.2 GPM
Cleaning Units (psi x GPM) 5170
Engine Specifications
RPM 3600
Rated Horsepower 6.0
Spark Plug Gap “.030” (0.76mm)
Gasoline Capacity 1.5 quarts
Oil (22 oz. capacity) SAE 30 weight
Generai Recommendations
The warranty of the high pressure washer does not
cover items that have been subjected to operator
abuse or negligence. To receive full value from the
warranty, operator must maintain high pressure
washer as instructed in this manual.
Some adjustments will need to be made period-
ocally to maintain your high pressure washer.
All adjustments in the Maintenance section of this
manual should be made at least once each season.
Once a year you should clean or replace the spark
plug, and clean or replace the air filter, and check
the gun and wand assembly for wear. A clean spark
plug and clean air filter assure proper fuel-air mixture
and help your engine run better and last longer.
Your pressure washer pump is a sealed pump, you
should never have to add or change the oil.
NOTE: Over time the o-rings in the gun assembly
become worn. Attached to your owners manual is a
replacememt o-ring and split backup o-ring.
11