Craftsman 919.762350 - Manual (Page 8)

A Warning: Read Owner’s Manual. Do not attempt
to operate equipment until you have read Owners
Manual for Sal€^, Operation, and Maintenance
Instructions.
Note: Included with your unit is a video cassette that
demonstrates how to operate your pressure washer.
If you have a video cassette recorder you should
view the video before operation.
A Warning: Never adjust spray pattern when spray­
ing. Never put hands in front of spray nozzle to
adjust spray pattern because you could be injured.
Stopping Your Pressure Washer
A CAUTION: Do not run pump without the water
supply connected and turned on. Failure to do so
will result in pump damage.
Move throttle control to the stop position to turn
pressure washer off.
THROTTLE CONTROL
BEFORE STARTING THE ENGINE
To operate the engine you will need to do the
following.
NOTE: Your pressure washer pump is a sealed pump
you should never have to add or change the oil
A CAUTION: Always check engine oil level before
every start. Running engine low of oil or out of oil
could result in serious damage.
Engine Oil
Your unit has been shipped without oil In the engine.
A bottle of SAE 30 weight oil is included in the carton.
Remove oil dip stick located on top of the engine. Oil
capacity is about 20 ounces of oil. The oil dip stick is
clearly marked with a line that tells you when unit has
enough oil. To check oil, place dipstick into oil fill.
Tighten dipstick then remove.Do not fill above this
point. Pour slowly.
NOTE: When adding oil to the engine crankcase, use
a high quality detergent oil classified for Service SF,
SG, SH, rated SAE 30 weight. Use no special addi­
tives. Select the oil’s viscosity grade according to your
expected operating temperatures.
• Simply shutting OFF engine will not release pressure
in the system. After engine has stopped, squeeze the
trigger on the spray gun for about 3 seconds to relieve
pressure. Spray stream will decrease in length.
IMPORTANT: This unit is equipped with a thermal relief
valve. If unit is allowed to run for several minutes
without pressing the trigger on the spray gun, several
drops of water may be released through this valve to
cool the unit. The heated water will be purged from the
bottom of the pump.
colder <---------------- 40°F ------------- > warmer
Synthetic 5W-30 1 SAE 30
Although multi-viscosity oils (5W30,10W30, etc.)
improve starting in cold weather, these multi-viscosity
oils will result in increased oil consumption when used
above 40°F Check your engine oil level more frequently
to avoid possible damage from running low on oil. Oil
sump capacity is about 20 ounces.
Gasoline
Your pressure washer engine is 4 cycle. Use fresh
unleaded fuel only.
BI!
^ CAUTION: Do not overfill the fuel tank. Always
allow room for fuel expansion.
WARNING: Never fill fuel tank indoors. Never
fill fuel tank when engine is running or hot. Do
not smoke or have open flame when filling fuel
tank.