Craftsman 247.372900 - Manual (Page 10)

Blade Control
Handle
Starter
Handle
FIGURE 8.
MULCHING OR MOWING TIPS
• For best results in normal and heavy mowing,
always run engine in “HI" speed position. “LOW”
speed is only for light cutting, trimming and fuel
economy.
• The grass condition at the time of mowing deter­
mines the proper mower cutting height setting for
best lawn appearance. For a healthy lawn, always
cut one-third or less of the total length of the grass
at any one cutting.
• Under certain conditions, such as very tall grass, it
may be necessary to raise the height of cut to
reduce pushing effort and to keep from overloading
the engine and leaving clumps of grass clippings.
• For extremely heavy cutting, use a slow ground
speed, and reduce the width of cut.
• Under heavy conditions cross cut for additional
mulching of surface debris.
CUSTOMER RESPONSIBILITIES
GENERAL RECOMMENDATIONS
• In order to maintain the warranty on your mower,
the customer is expected to perform the mainte­
nance as outlined below.
Once a year you should replace the spark plug, air
filter, and check blade for wear. A new spark plug
and air filter assures proper air-fuel mixture and
helps your engine run better and last longer.
MAINTENANCE SCHEDULE
SERVICE RECORD
Fill in dates as you
complete regular service
SCHEDULE SERVICE DATES
Every
Use
After
First
Two
Hours
Every
25
Hours
Check Engine Oil V
Lubricate Mower V
Blade Care V
Change Engine Oil yf
Spark Plug Replaced y/
Air Filter Replaced yf
Cleaning V
VCHECK
10