Craftsman 247.298760 - Manual (Page 8)

C. Secure with hex center locknut (G). See figure
9.
Pivot Arm
Assembly
t"
/
FIGURE 11.
FIGURE 9.
H^^NOTE
Tighten hex locknut just to the point
the rubber washer starts to
conn press.
4. Control Rod.
A. Place control rod through slot in handle panel,
hook end of rod goes towards the front of
tiller. See figure 10.
FIGURE 10.
B. Hook control rod in hole provided on pivot arm
assembly as shown In figure 11. Secure
control rod to pivot arm assembly with hair pin
cotter (C). See figure 11.
C. Please note there are three holes left on the
shift lever. Use the second hole from bottom
for the next step. See figure 12.
Shift Lever
Second Hole
From Bottom
FIGURE 12.
D. Place shift lever in first gear and thread ferrule
(D) on end of control rod until ferrule lines up
with second hole on shift lever. See figure 13.
Secure with hair pin cotter (C). See figure 13.
FIGUREIS.