System overview – Iris Sample Processing Statspin® MP Multipurpose Centrifuge User Manual
Page 6

2
Section
2
System Overview
Principle and Intended Use
For in vitro diagnostic use for rapid separation of whole blood, preparing urine sediment for
microscopic analysis and centrifuging microhematocrit tubes for packed cell volume
determination.
The StatSpin MP is a small, quiet high speed centrifuge. It employs a unique, proprietary drive and
suspension system which results in nearly vibration free operation. Light-weight, low mass rotors
achieve both top speed and full braking in a few seconds. This StatSpin instrument is designed to
meet international safety standards.
Symbols and Definitions
Start button
The start button initiates a pre-timed cycle at a fixed
speed. NOTE: The StatSpin MP does not have an
on/off switch and is normally left plugged in and “on”.
Stop/open button
The stop/open button interrupts the cycle and stops
the centrifugation. This button may also be used to
release the cover.
Cycle selector
This button allows for selection of the appropriate
cycle.
Error/Service
indicator
The red LED identified, as error/service is illuminated
continuously or flashing when service is required.
Power input
DC Power Input: 24V DC Plug-in
REF
Product/Reference
Number
Indicates the StatSpin product/catalog number
Caution
Statement of caution/warning, read instruction
carefully
Temperature
limitation
Indicates storage requirements range
IVD