Baseline Systems BaseStation 1000 - Manual (Page 15)

BaseStation 1000 Quick Start Guide
Page 9
Moisture Pause
If you have a soil moisture sensor installed, you can use this option to have a program pause
when a specified soil moisture sensor limit is reached.
E. Switch Pause
If you have an event switch device installed, you can use this option to have a program pause
when a specified switch condition occurs.
Temperature Pause
If you have an air temperature sensor installed, you can use this option to have a program
pause when a specified temperature is reached.
Setup Prg. Stop
Set up a condition that will cause a running program to stop when that condition occurs.
Moisture Stop
Switch Stop
Temperature Stop
MV/Pump
Use this option to associate a master valve or pump start biCoder with a program. Before you
perform this procedure, you must assign a biCoder as a master valve or pump biCoder.
Water Source
Use this option to associate a water source with a program.
Flow Setup Menu
Water Source Setup Menu
Water Source # Setup Menu
Flow Sensors
If you have a flow sensor connected to your system, you can assign it to a water source.
MV/Pumps
If you have a master valve/pump start biCoder connected to your system, you can assign
it to a water source.
Flow Management Menu
Limit Zones by Flow
Enter a target flow in gallons per minute (GPM) for the water source that supplies
water through the flow device to the rest of the irrigation system. The BaseStation