B&G H5000 Analogue Expansion - Manual (Page 49)

|
49
Commissioning | H5000 Installation
Commissioning
If an H5000 Pilot Computer and H5000 Pilot Controller are connected
to the network then autopilot control and setup functionality can be
accessed via the H5000 Pilot Controller.
Warning: The installation settings must be performed as part
of the commissioning of the autopilot system. Failure to do so
correctly may prohibit the autopilot from functioning properly!
The Installation menu can only be accessed in Standby mode.
Dockside
The dockside procedures are initiated from the commissioning
dialog via the H5000 Pilot Controller.
Boat length
Set the boat length of the vessel.
Drive voltage (V)
Set the drive voltage type to 12 or 24 V
11