B&G H5000 Analogue Expansion - Manual (Page 4)

|
3
Liability & Safety Warning | H5000 Installation
Liability and safety warning
Navico accept no responsibility for the use and/or operation of this
equipment. It is the user’s responsibility to ensure that under all
circumstances the equipment is used for the purposes for which it
has been designed.
Warning: Calibration
The safe operation of this equipment is dependent on accurate and
correct calibration. Incorrect calibration of this equipment may lead
to false and inaccurate navigational readings placing the yacht into
danger.
Warning: Operational Hazard
The H5000 system is an electronic navigation aid and is designed
to assist in the navigation of your yacht. It is not designed to totally
replace conventional navigation procedures and precautions. All
necessary precautions should be taken to ensure that the yacht is not
placed into danger.
The Pilot is an aid to steering the vessel. It is the user’s responsibility
to ensure safe control and movement of the vessel at all times.
Caution: Electrical Supply
This equipment is designed for use with a power supply source of
12 V DC. The application of any other power supply may result in
permanent damage to the equipment.
Caution: Cleaning
The use of alcohol or solvent-based cleaners will damage this
equipment and any warranty in force will be invalidated.
Caution: Processor Installation
All B&G Processors should be installed below decks in a dry location
protected from water and moisture.
Power Off Disclaimer
When in standby mode the H5000 system continues to consume
power. To conserve the vessel’s battery life switch off power at the
main breaker.