B&G H5000 Analogue Expansion - Manual (Page 15)

|
15
System architecture | H5000 Installation
Wiring guidelines
The network cabling should be such that the network cable run is
predominantly in a linear layout with a start point and end point
(which are terminated). “Star” shaped layouts are ineffi
cient, may
cause incorrect operation and should be avoided.
 Note:
H5000 uses Micro-C network cabling compatible with NMEA
2000 devices.
Don’t do this... Do this...
Don’t make sharp bends in the
cables
Do make drip and service loops
Don’t run cables in a way that
allows water to fl ow down into
the connectors
Do tie-wrap all cables to keep
them secure
Don’t route the data cables
in areas adjacent to radar,
transmitter, or large current
carrying cables If cables are shortened,
lengthened, or re-terminated, do
insulate and protect all wiring
connections
Do leave room at the back to
install and remove cables
! Warning : Before starting the installation, be sure to turn
electrical power off . If power is left on or turned on during the
installation, fi re, electrical shock, or other serious injury may occur.
Be sure that the voltage of the power supply is compatible with the
system.