Great Plains Auxiliary Hydraulic Kit - Manual (Page 7)

Great Plains Mfg., Inc.
Installation Instructions 7
05/05/2009 401-466M
Refer to Figure 15. Figure 14 shows the planter folded in order to
depict the entire routing. Both Figures also show the hoses tied and
clamped; not done at this step.
Route the hoses ( or ) from the seed cart to the
selector valve
42. Align them with the hose rack between cart and
wings.
43. Leave a small amount of slack (about 6in inches
side to side) near the wing pivot area .
Note: There needs to be sufficient slack at the pivot
point to prevent stress on the hose during folding
and unfolding.
44. Lay them on top of the hose support frame
along the wings.
45. Leave all of the remaining slack at the wing end ,
near the new selector valve.
Refer to Figure 16
46. Select one:
502-068D HYD HOSE CLAMP BRACKET
and two each:
802-009C RHSNB 5/16-18X1 1/4 GR5
804-009C WASHER LOCK SPRING 5/16 PLT
803-008C NUT HEX 5/16-18 PLT
47. Insert each round-head carriage bolt in one of
the two square holes in a mount installed dur-
ing step 19 through step 21.
48. Slide a clamp over the bolt threads and loosely
attach a lock washer and nut .
49. Place the hoses ( or ) in the clamp and finger-
tighten the nuts.
50. Repeat step 46 through step 49 for each mount
.
Figure 14
Wing Hose Routing
25407
1
1
2
3
3
3
4
31 34
31 34
1
2
3
4
Figure 15
Hoses at Unfolding
25418
1
1
1
1
Figure 16
Hoses in Wing Clamps
25408
U
D
F
B
L
R
31 34
14
23
21
18
15 15
18
23
21
18
14
15
23 21
31 34
14