Mount and assemble selector valve – Great Plains Auxiliary Hydraulic Kit User Manual
Page 3
Great Plains Mfg., Inc.
Installation Instructions
3
05/05/2009
401-466M
Mount and Assemble Selector Valve
10. Select one:
and two each:
11. Mount the selector valve
on the new bracket
at the notches, using the
3
⁄
8
in fasteners.
12. De-grease the bracket surface immediately above
the new valve, and apply the operating decal
13. Select two each:
14. Loosely install the O-ring boss end of each adaptor
in one of the Front (marker) ports of valve
.
15. Select four each:
16. Loosely install the O-ring boss end of each elbow
in each remaining face (Left) and rear (Back)
ports of the valve
.
17. Orient the Left (face) ports
so that the JIC ends
point Down and Front.
18. Orient the Back (Aux) ports
so that the JIC end
point Up and Right (toward machine center).
Figure 4
Mount Selector Valve
25397
U
D
F
B
L
R
Figure 5
Install Valve Fittings
25398
U
D
F
B
L
R
Figure 6
Fitting Orientation
25399
U
D
L
R
B
F
1