Lexicon MPX 1 - Manual (Page 90)

Lexicon
7-16
MPX 1 User Guide
Mix 0-100% Dry/Wet ratio
Level Off, -89 to +6dB Amount of effect in the processed signal
Fc 100-10000Hz Crossover frequency
Bal -50 to +50 Relative level of the low and high band
The Crossover effect is similar
to Fc Splitter, but with only one
crossover frequency, shared by
low and high. In this effect, Level
and Bal are not interpolated.
Mix 0-100% Dry/Wet ratio
Level* Off, -89 to +6dB Amount of effect in the processed signal
LoCut 100-10000Hz Corner frequency for the low cut (highpass)band
HiCut 100-10000Hz Corner frequency for the high cut (lowpass) band
Bal* -50 to +50 Relative level of the low and high band
The Fc Splitter effect splits a
mono input into a low-passed out-
put on the left channel and a high-
passed output on the right, with
independent control of the corner
frequencies of both filters. If the
corner frequencies are the same,
and the balance is set to 0, the
frequency response will be flat
when the two outputs are summed.
Bal controls the relative level of left
and right outputs. When Bal=0, the
left and right outputs are not at-
tenuated. Negative values attenu-
ate the right output (highs). Posi-
tive values attenuate the left (lows).
* = Interpolated; ( ) = Option of preceding parameter
Crossover
Fc Splitter
Fazer Tremolo OD Rotary
OpenTheDoor