Wood’s Powr-Grip PT410AC - Manual (Page 16)

Rev 11.3/2-13 14 PT410AC: #35140
A
FTER
U
SING THE
L
IFTER
Place the power switch in the OFF position ( ).
CAUTION: Do not set the lifter against any surfaces which could soil or damage the
vacuum pads.
Use the hoisting equipment to gently lower the lifter onto a stable support; then detach the
hoisting equipment hook from the lift spool.
If the lifter is transported to another location, use the original shipping container and secure the
lifter so as to protect the vacuum pads and all other components from damage while in transit.
Storing the Lifter
Use the covers supplied to keep the vacuum pads clean.
!!-CE-!! In accordance with CE Standard EN 13155, the lifter is designed to rest on relatively
horizontal surfaces without tipping over. To store the lifter in this way, set the lifter with the
pads facing downward on a clean, smooth, flat surface. Then lower the lift bar to a horizontal
orientation (see OPERATION: T
O
T
ILT THE
L
OAD
) and place a support under the lift spool.
However, see the Note immediately following.
Note: Storing the lifter with its pad frame and lift bar in the horizontal orientation could damage
the tilt actuator, if the lift bar is not supported. Avoid placing the lifter in this position; or if this is
unavoidable, place a support under the lift bar. Also be sure to provide manual assistance to the
tilt actuator when raising the lift bar to the vertical position (see ASSEMBLY).