Online manual not for resale purposes – BLITZ R-VIT i-Color User Manual

Page 16

②Operating Method

Press the LEFT switch to shift from night and day illumination and vice versa.
Press the LEFT switch for over 3 seconds and it will only clear the peak value of the displayed data.
Press the UP switch to shift from Needle Meter → Dual Digital Meter → Six Fold Meter → Fuel Injection Trace
→ A/F Graph → Needle Meter. Press the UP switch for over 3 seconds and it will scroll back wards.
Press the DOWN switch and the displayed items will shift from Speed / RPM / Water Temp / Ignition Timing /
Injection Time / Airflow Voltage / Intake Temp / Outside Temp / Intake Manifold Press / Boost / O2 Voltage / O2R
Voltage / A/F 1 / A/F 2 / Intake Air Mass / Battery Voltage / Throttle Position / AT Temp / Gear Position / 4 WD Ratio
/ Fuel Press / Momentarily Fuel Consumption / External Voltage Input / External Temp Input. Press the UP switch
for over 3 seconds and it will scroll back wards.
Press the RIGHT switch and will go back to the ICON MENU.
Turn the ENCODER and the of the meter will shift from White → Black → Carbon → Blue → White.
Press the ENCODER for over 3 seconds and it will shift from the “Second” to the “Fourth” displaying data setting
mode. It will return to the previous display if any operation in not taken for over 10 seconds while on setting mode.
The value will be the same as the needle meter at the “Second displaying data” if the METER PK is set. Moreover,
a blank cannot be set.

④Peak Mark

There is a slight difference in the location for the Peak Mark and the actual digital
value of the Peak value. For example, the digital peak value is set at 0.80 hkPa but
the Peak Mark would be located at 0.804 hkPa.

There is also a slight difference in the location of the Warning Mark and the set
warning digital value because of the digitally processed dots.

⑤Warning Mark

The “second” to the “fourth” digital displayed item will turn the set color when it
reaches the set warning value. The source of the warning will pop out when the
warning reaches the set value.

The needle center will turn red and blink when the first item displayed at the needle
meter reaches the set warning value.

③Warning

A Popup will be displayed at the bottom right corner while the Electric Fan / Fuel

Pressure active control is activated.

⑥Active Control Popup Display

Online Manual Not For Resale Purposes