Other setting 2, Online manual not for resale purposes – BLITZ R-VIT i-Color User Manual

Page 14

Other setting 2

①Warning Setting

1) Select “Warning” at the “Function”.
2) Select the desired source (25 Items) to configure the warning.
3) Select “Warning Switch” and configure ON or OFF.
4) Select “Buzzer” and configure ON of OFF.
5) Select “Watch Direction” and configure the direction to be monitored (Over/Under).
6) Select “Set” and configure the value of the warning.

②Voltage Input Setup Setting.

1) Select “Voltage Input Setup” at the “Function”.
2) Select “Low” and configure the minimum input voltage value.
3) Select “Fit (Low)” and configure the minimum display value of the minimum input voltage.
4) Select “High” and configure the maximum input voltage value.
5) Select “Fit (High)” and configure the maximum display value for the maximum input voltage.
6) Select “Unit” and type in the unit for the Fit value.

※ An automatic configuration for the “A/F Box” will take place by keeping pressing the “UP” switch or “Press

Sensor” by pressing the “DOWN” switch.

③Unit Setting.

1) Select “Unit” at the “Function”.
2) Select Speed and configure the unit for vehicle speed from km/H or MPH.
3) Select “Injection” and configure the injection time unit.
4) Select “Air Flow” and configure the unit of the airflow sensor.
5) Select “Throttle” and configure the unit of the throttle sensor.

※ The display unit will be in % when the configuring value is other than 0 when configuring steps 3) ～ 5).

Input such as Xms = 100% or Xv = 100%. As an example on step 5), input 3.50 since the voltage is 3.5V
at full throttle (100%).

Online Manual Not For Resale Purposes