Barco Nio Fusion 4MP - Manual (Page 25)

Display information
25
Note:
• The DPMS system will power down the display when the
connected computer is left idle for a certain time.
Barco recommends to switch DPMS on to prevent image burn-in
(image retention) on the LCD panel.
• To enter the user controls keycode, the OSD must not be
visible. Touch any of the soft touch keys to switch on the front
illumination. While the illumination is on, touch the following
keys in successive order: Enter
, Down , Up , Down ,
Enter .
Input Switch Mode Select “Auto” if you wish the display to
select the video inputs automatically. If
only one video input is connected, the
image will be shown in the center of
the screen. If both video inputs are con-
nected, the video signal connected to
the “Left” input is shown on the left
side of the screen and the signal con-
nected to the “Right” connector is
shown on the right side. If one of the
video signals exceeds the resolution of
1280x1600, the signal is suppressed.
Select “Left” to display only the signal
connected to the “Left” video input.
Select “Right” to display only the signal
connected to the “Right” video input.
Preferred Input Select the video resolution you wish the
connected graphic board(s) to repro-
duce. After changing this setting you
must reboot the PC so that the graphic
board changes its resolution.
This function takes effect with plug-
and-play graphic boards only.
Name Description