Barco Nio Fusion 4MP - Manual (Page 20)

Display information
20
2. A warning message appears. Press the Stand-by touch key again
to switch the display into stand-by or press any other key to
keep the display in on state.
To switch from stand-by to on state:
1. Touch any of the soft touch keys.
The front illumination is switched on for about 10 seconds.
2. While the illumination is switched on, touch the Stand-by
touch key to switch the display on.
Info messages
The following messages may appear automatically on the screen:
Input Selection
The Input selection menu appears in case 2 video signals are
connected and the resolution of one or both video signals is too high
to display them both.
In that case the input selection menu allows you to select one of both
video signals.
No signal selected
This message appears in case the display finds no proper video signal
at its inputs.
Resolution too high
This message appears in case the resolution of the selected video
signal is too high to display.
Text mode / Diagnostic mode
These messages appear for a few seconds directly after switching to
Text mode or Diagnostic mode.
In text mode, the display luminance is approximately half of the
luminance in diagnostic mode. Text mode is intended for using the