Aiwa BMZ-K1 - Manual (Page 12)

12
En
To clear the entire program
Press s in stop mode.
To add a track to the program
Repeat steps 2 and 3 before starting playback. The track is
added to the end of the program.
To cancel programed play
In stop mode, press PLAY MODE repeatedly until “PGM”
disappears.
•The program content is retained even if the program
cancelled or after programmed playback finishes. The same
program plays back if you carry out step 1 and 5. However,
the program content is cleared when you eject either of CDs.
When transporting the unit
Please carry out procedures below to prevent the breakage
of CD mechanism.
1 Eject all the CDs.
2 Hold down s on the main unit for 5 seconds
in CD function when the unit is turned on.
“MECHA LOCK” appears in the display, and then
the unit will turn itself off automatically.
3 Disconnect the AC power cord from the wall
outlet.
Notes on CDs
•Do not tilt the unit with a disc inserted.
•Discs recorded on CD-R/RW drives may not be played back
because of scratches, dirt, recording condition or the drive's
characteristics.
•CD-R/RW discs which are not finalized at the end of
recording cannot be played back.
•Do not load an unrecorded CD-R/RW disc. The disc may be
damaged.