Aiwa NSX-AJ800 - Manual (Page 5)

5
En
Main unit: rear
1 AM LOOP, FM 75
Ω
terminals
Plug in the supplied AM and FM antennas here.
2 VIDEO/AUX jacks
Accepts analog sound signals from external equipment.
Connect using an optional connecting cable with RCA
phono plugs (red plug to R jack, white plug to L jack).
Refer also to the operating instructions of your equipment.
To switch function to external input, press VIDEO/AUX
to select the VIDEO (AUX/TV) function.
Tip:
To change the displayed name for this function, turn the
unit on, then hold down VIDEO/AUX and press POWER.
Repeat the procedure to select one of "VIDEO", "AUX"
or "TV".
3 SATELLITE SPEAKERS 3 jacks
Connect the speaker cord of the satellite speakers here.
4 FRONT SPEAKERS 3 terminals
Connect the speaker cord of the supplied front speakers
here.
5 AC power cord
To mount the satellite speakers on the wall
Mount each speaker on a spot that can hold its weight.
AIWA disclaims any responsibility for injury to persons
or other accidents caused by not fitting the satellite
speakers properly or if the place of the installation is not
suitable.
Remote control
Detach the battery compartment lid at the rear of the remote
control and insert two R6 (size AA) batteries with correct
polarity.
•Replace the batteries with new ones when the operational
distance between the remote control and main unit becomes
shorter.
•Remove the batteries if the unit is not going to be used for
an extended period of time.
•The remote control may not operate if it is used under intense
sunlight, etc., or if its line of sight is obstructed.
PARTS AND CONTROLS