Konica Minolta MSP3500 - Manual (Page 70)

2-38
Scann
er
Ch
ap
te
r 2
21. Registering the Job Program
The present setting state can be registered in up to 3 program registration locations (1J, 2J
and 3J).
1 Press the Memory Input Key in the Setting mode. 1J starts blinking.
Memory Input Key
To change the program registration location, press the Multi-Print Key. The display is
switched in order of 1J
→ 2J → 3J →1J.
2 Select the program registration location (1J, 2J or 3J), and press the Memory Input Key
again.
3 When all LEDs on the control panel light up and then the normal display is resumed,
the program registration is over.
The program can be registered up to 3 programs for the PR connection and up to 3 programs
for the PC connection.