AGFA 1200 User Manual
Page 34
Chapter 2: Installing the Scanner
34
"
Note: Make sure that you are using the correct power cord for the voltage in your area.
Double-check whether the voltage indicated on the back panel of the scanner
corresponds with the voltage in your area. If not, contact your dealer or Agfa service
representative.
2
Check if the SCSI cable is properly connected.
3
Switch on the scanner.
"
Note: While starting up the scanner, the power indicator (green) switches on after which
the progress indicator switches on. The scanner performs a self-test for about 25
seconds. At the end of the self-test, the progress indicator will automatically go out if
there are no problems. If a malfunction is detected during the self-test, that is, if the
progress indicator remains blinking, consult
4
Switch on any other SCSI device you may have attached, and wait for it to start up.
5
Switch on your PC.
6
Windows will detect the scanner.