AGFA 1200 - Manual (Page 32)

Chapter 2: Installing the Scanner 32
If your scanner is the first external device of your SCSI chain
1 Set the scanner to an unused SCSI ID number between 0 and 6.
For more information, see Choosing a SCSI ID Number .
2 Connect the 25-pin end of the SCSI cable to the connector of the next device in the SCSI
chain.
" Note: If you do not have the appropriate cable, contact your dealer for a specific cable.
3 Tighten the connector screws to secure the connection.
4 Connect the 50-pin end of the SCSI cable to the connector of the scanner.
5 Snap the diamond shaped wire clips into the clip brackets to secure the connection.
6 Make sure that the last device in the chain is terminated.