Festo Контроллер крайних положений SPC11 - Manual (Page 15)

1. Installation instructions for the DNCM-...-POT
1-3
Festo P.BE-SPC11-DNCM-EN en 0204NH
1.1 General instructions
Warning
Faults in the system structure and incorrect parameters
can cause the piston to move to an end position uncush-
ioned. The fixed stop or the drive may then be damaged.
You must observe the following instructions in order to
prevent such damage.
• Pay special attention to the design of the system. Always
observe the safety instructions and information in this
manual as well as in the system manual for type
P.BE-SPC11-SYS... .
• Use only the special matching components from Festo for
setting up and connecting the system. Only in this way
can you guarantee the correct functioning of the system.