Hawk Industries Spinner Manual 550 HYDRAULIC Serial Numbers 206 to 591 - Manual (Page 33)

33 Maintenance & Repair
Air Power Pack Maintenance
BODY ASSEMBLY
SEAL HOLDER
DEFLECTOR / SHROUD
GASKET (ELEMENT)
HOLDER (ELEMENT)
BOWL ASSEMBLY
AUTO DRAIN
( Looks different than shown)
BAFFLE
GASKET (ELEMENT)
SEAL (BODY TO BOWL)
ELEMENT (FILTER)
1. The air filter element should be
changed once every three (3)
months.
2. Unscrew the air filter bowl
(AFB) and replace the element.
3. The filter is an auto-drain type.
Make sure the auto-drain
system is working correctly
by checking the fluid level
sight gage (FSG) on the side
of the bowl. If the fluid level is
higher than the middle of the
sight gage, the auto-drain is
mal-functioning. Replace the
auto-drain as shown in the filter
diagram below.
Changing Air Filter Element
FSG
031-F17 Air Filter
Air Filter Maintenance
ELEMENT 002-F17-1
ITEM P/N
DRAIN 002-F17-2
NOTE
Clean and dry air is essential for
maximum Spinmaster performance
and dependability.
AFB