Safety information – Sony PRS-T2BC User Manual
Page 160
Search
Top page > Other Information > Precautions > Safety Information
Safety Information
Protected content
Protected content is limited to personal use only. Use of the content beyond this limit requires
permission of the copyright holders.
Handling the Reader
In order to comply with FCC radio-frequency radiation exposure guidelines for an
uncontrolled exposure, this device and its antenna must not be co-located or operating in
conjunction with any other antenna or transmitter.
If the Reader causes interference to radio or television reception, turn the Reader off and
move it away from the radio or television.
Refrain from using the Reader according to the in-flight announcements during take off or
landing in an aircraft.
Do not drop, or put any heavy object on top of the Reader or apply a strong shock to the
Reader. It may cause a malfunction or damage.
Never subject the Reader to extremes of light, temperature, moisture or vibration.
Do not leave the Reader on an unstable surface.
Do not poke people using the supplied stylus.
Do not treat or use the supplied stylus roughly, such as bending it, or scratching the
touchscreen with it.
Use the supplied stylus only for touchscreen operations.
Do not use the stylus if it is damaged or deformed.
If any object is placed on the touchscreen, it may cause a malfunction. When not in use, leave
the Reader in sleep mode, or turn it off.
When using the Reader internationally, it is your responsibility to ensure that the Reader is
used in compliance with the following specifications:
AC voltage
Wireless products regulations
Other safety regulations or requirements
Be sure not to short-circuit the terminals of the Reader with metallic objects.
Never leave the Reader exposed to high temperature, such as in a car parked in the sun or
under direct sunlight.
Avoiding water and moisture
Note that condensation may form temporarily in cases such as when the player is moved
quickly from a low-temperature environment to a high temperature environment or used in a
room that has a heater just turned on. Condensation creates a phenomenon where moisture
in the air adheres to surfaces such as metal panels, etc., and then changes to liquid. If
condensation forms in the Reader, leave it turned off until the condensation disappears. If you
use the Reader with condensation present, a malfunction may result.
The Reader is not waterproof. Remember to follow the precautions below.
Be careful not to drop the Reader into a sink or other container filled with water.
Do not use the Reader in humid locations or bad weather, such as in the rain or snow.
Do not get the Reader wet.
If you touch the Reader with wet hands, or put the Reader in a damp article of clothing, the
160