AT&T 9452 - Manual (Page 8)

INSTALLATION
6
Table/Desk Installation
1 Connect the power cord.
Use only the power cord supplied with this product. If you
need a replacement, call 1 800 222-3111.
2 Charge the handset battery.
Place the handset in the base. Charge the battery for at least 16 hours
the first time. After the first charge, the battery is typically fully
charged overnight.
3 Connect the telephone line cord(s).
If you have a two-
line jack, use only the
4-wire (RJ-14) line cord.
Connect the line cord
from the wall jack to
the jack labeled
L1/L1+L2 on the base.
Make sure the plugs
snap firmly into place.
If you have two separate
jacks, use both long line
cords. Connect a line cord
from the wall jack you
wish to designate as
your Line 1 to the jack
labeled L1/L1+L2 on the
back of the base.
Connect the other line
cord from the remaining
wall jack to the jack
labeled L2 on the back
of the base. Make sure
the plugs snap firmly
into place.
Standard
electrical
outlet
L1/L1+L2 jack
Power cord
Modular
telephone
jack
Standard
electrical
outlet
Modular
telephone
jacks
L1/L1+L2 jack
L2 jack
Power cord
9452_book_1ATT 10/5/00 3:17 PM Page 6