AT&T 9452 - Manual (Page 24)

Answering System Feature Setup
You can set up one feature at a time, or you can set up a feature and then
move on to set up another feature.
1 Make sure the answering system is on.
2 Press and release
U until you hear the system announce the
feature you want to set. Refer to the “Feature Summary” below for a
description of the features and your choices.
3 Press
S to hear the feature’s settings.
4 Press
t to confirm your selection.
NOTE: Exit Feature Setup at any time by pressing a MAILBOX button.
Feature Summary
Asterisk ( * ) indicates default settings.
System announces: Description/directions:
“Set Outgoing Message” See “Record Your Announcement” on
page 21.
“Set Security Code” Set the remote access code you will use
19 * to access features and functions of the
answering system from a touch tone phone.
“Set Day and Time” Set the clock: After you set the day, repeat
Steps 3 and 4 in “Answering System
Feature Setup” to set hours and minutes.
“Set Audible Message Alert” When Message Alert is turned on, the base
Off * beeps once every 10 seconds when new
On messages have been received.
“Set Announce Only” When you turn on Announce Only,
Off * callers hear your announcement, but
On cannot leave a message.
“Set Call Screening” When this feature is set to On, you can
On * hear messages at the base as callers
Off are recording them.
“Set Number of Rings” Choose how many times the phone will
2 ring before the system answers a call.
4 * With Toll Saver active,the system answers
6 after two rings when you have new
Toll Saver messages and after four rings when you
have no new messages.
ANSWERING SYSTEM OPERATION
22
9452_book_1ATT 10/5/00 3:18 PM Page 22