AT&T 9452 - Manual (Page 11)

FEATURE SETUP
9
Telephone Feature Setup
1 Make sure the handset is off.
2 Press
G.
3 Press
- until the feature you want to set is flashing on the screen.
(Features are described in the chart below.)
4 Press
S.
5 Press
- or + until the setting you want flashes.
6 Press
S
— OR —
If necessary, use the keypad to enter numbers (for example, when you
program the area code), then press
S.
Telephone Features
Feature: Directions:
AREA-HOME Select HOME. The screen displays ENTER AREA CODE.
If you live in an area where you make calls within your
own area code by dialing seven digits, enter your three-digit
area code, then press
S
— OR —
If you live in an area where all local calls require 10 digits
(area code plus phone number, without dialing “1” first),
enter
000 for the area code, then press S.
AREA-LOCAL An area code is local if you do not dial “1” before the area
code. Enter up to five three-digit local area codes. Select
LOCAL, use - or + to move from area code #1 through
area code
#5, and enter area codes. Press S to save.
KEY BEEPS If you turn this feature on, the handset sounds a tone
every time you press a button. Select
KEYBEEPS, press -
until OFF or ON is flashing, then press S.
RINGER You can choose from four different ringers for each line.
Press
- or + until LINE 1 or LINE 2 is flashing, then
press
S. Press - to hear the different ringers, then
press
S to save the last ringer heard or choose OFF.
Repeat for the other line, then press
O.
NOTE: When editing an area code, use
+ to delete existing digits, then
enter the new area code. Press
S to save.
9452_book_1ATT 10/5/00 3:17 PM Page 9