Corn cooker, Installation – A.J. Antunes & Co CCC-20T 9600220 User Manual
Page 6

CORN COOKER
6
P/N 1010946 Rev. A 09/06
STAR
T/ST
OP
STAR
T/ST
OP
HEA
T
Figure 1. Corn Cooker
Unpacking
1. Remove unit and all packing materials from ship-
ping carton.
2. Open the large box. Remove all packing materi-
als and protective coverings from the unit and
parts.
3. Wash baskets in soap and water. Wipe all sur-
faces of the unit with a hot damp cloth.
NOTE: Do not use a dripping wet cloth. Wring out
before use.
4. Install baskets into unit.
NOTE: If any parts are missing or damaged, con-
tact Antunes Technical Service IMMEDIATELY at
1-877-392-7854.
Equipment Setup
When placing the unit into service, pay attention to the
following guidelines.
• Make sure the controls are positioned at the rear
to ensure adequate room for loading and unload-
ing baskets.
• Make sure power to the unit is off and the unit is
at room temperature.
• Do not block or cover any openings on the unit.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do not allow cord to hang over edge of table or
counter.
• Connect the unit to the power supply. Refer to
the specification plate for the proper voltage.
INSTALLATION
CAUTION
All electrical connections must be in accordance
with local electrical codes and any other appli-
cable codes.
Safety Interlock Switch
Beneath Head Assembly
Head
Assembly
Pan
Pan
Baskets
Figure 2. Corn Cooker Accessories