Anthem MRX 700 - Manual (Page 33)

25
3. SETUP
continued …
3.10 GENERAL CONFIGURATION
This menu allows you to define the power-on volume settings, save.load settings, and configure RS-232.
Power-On Volume:
When you turn Main or Zone 2, the volume for each will be at the levels you have set in this menu. This
prevents surprises when not knowing the volume someone had set when turning the receiver off, then
having the power-on volume be too loud or quiet. The default is -35 dB.
Load Factory Defaults:
After selecting and confirming, all menu settings will be reset.
Save/Load User Settings:
After selecting Save User Settings and confirming, all menu settings will be stored. If you change settings
later and want to recall the saved settings, select Load User Settings and confirm.
RS-232 Baud Rate (normally for use only by custom installers):
Select 19200 or 115200.
General Configuration
Power On Volume 4
Load Factory Defaults
Save/Load User Settings
RS-232 Baud Rate
115200