Anthem MRX 700 - Manual (Page 17)

9
2. CONNECTIONS
continued …
2.4 ETHERNET (not available on MRX 300)
This connection is required for Internet radio. Connect your router using CAT 5 cable or a wireless bridge.
2.5 ANTHEM MDX 1 DOCK (optional)
Connect using the special cable that’s supplied with the dock. Further connection instructions are provided
with the dock.
2.6 12 VOLT TRIGGER
If another system component has a trigger input it can be activated by the receiver.
Connect the receiver’s trigger output using a cable with 3.5mm mini plugs.
The receiver provides flexible trigger options. Through the setup menu, you can specify the conditions for
enabling triggers (see section 3.9).
2.7 INFRA RED INPUT
An external IR receiver allows the remote control to be used from another location in your home. Once an IR
receiver is wired to another room, connect it to the IR IN input.
2.8 INFRA RED OUTPUT
IR emitters allow control of your source components from any location in your home that has an IR receiver
connected to the receiver. After positioning the IR emitter according to its instructions, connect it to IR OUT.
Commands through the rear panel IR IN are re-transmitted through IR OUT.
2.9 SWITCHED AC OUTLET
This can be used to power smaller devices which require no more than 50W. Power at the outlet is turned
off when the receiver is turned off.
2.10 POWER
Connect the power cord to the receiver and the power source.