Rubbermaid 402060 - Manual

Manufactured by:
T ECHNICAL C ONCEPTS • 1-800-551-5155
®
AutoFlush
®
Clamp
Next Generation
with Courtesy Flush (Toilets)
without Courtesy Flush (Urinals)
for Sloan and Zurn Models
The AutoFlush ® sends out a continuous infrared beam that is reflected back by the presence of a person in front of the urinal
or toilet.“Object Lock” technology differentiates between someone walking past the unit or actually using the fixture.
If flush handle is leaking, replace before installing AutoFlush ®
AutoFlush ® for Urinals
AutoFlush ® for Toilets
4 “C” Alkaline Batteries
AUTOFLUSH ® COMPONENTS
- +
- +
Using the supplied Allen wrench,
remove battery compartment.
INSTRUCTIONS
2.1 Open hinged screw covers
and loosen screws to leave a
1 ⁄ 4 ” gap between the base
and mounting cover
2.2 Slide the AutoFlush ® on to
the flush handle and secure
the mounting clamp over the
existing handle base.
NOTE: If the unit is on a high mount
toilet flush valve where the flush han-
dle is approximately 40” above the
floor, you should rotate the AutoFlush
®
down to ensure sensor is directed
at user.
2.1a
1/4” Gap
2.1b
2.2a
Install 4 “C” cell alkaline batteries
into the battery compartment not-
ing the battery position marks on
the inside of the compartment.
Slide the battery compartment into
the AutoFlush
® unit and secure
compartment with Allen wrench.
The last three turns of the wrench
will activate the AutoFlush
® unit.
- - +
- + +
2.2b
NOTE: Fits Sloan and Zurn flush handles. To fit other flush handles contact TC customer service at 800-551-5155.
Step 1.
Step 3. Step 2.
Sensor
Adjustment Tool
Allen Wrench
Courtesy Flush Button