Innovate Motorsports OT-1 - Manual (Page 22)

- 22 -
4.4 Configure the OT-1 Channels for the proper OBD-II value
By default, LogWorks assumes that the 16 channels match the first 16 Inputs from the list of
supported OBD-II PIDs. So, chances are that you will have to reconfigure the channels in
LogWorks to match the actual configuration of your OT-1.
Do this by selected Channels->Configure Channel from the menu on the main screen. The
following dialog box will appear:
Only the top portion of the Dialog normally needs to be altered. You will generally want to
change the Input Name (top right) to something meaningful. This is how the channel is listed in
LogWorks. It is also advisable not to use spaces (‘ ‘) in the name, since the spaces would be a
problem if you want to use some of LogWorks more advanced features, like math calculations,
later.
Immediately under the Input Name field is the “Input Mode” field for the selected channel on the
OT-1. Set this list to match the OBD-II Input assignment made in LM Programmer. This will
populate the bottom of the dialog with proper values for that OBD-II value.
When you are done configuring the channel, select OK.