Innovate Motorsports LM-1 Quick Start Guide User Manual
Lm-1 quick start guide
LM-1 Accessories:
LMA-2: Auxiliary Input #2 (RPM converter): #3726
LMA-3: Auxiliary Input #3 (AuxBox- RPM, Temp,
Duty Cycle, Acceleration, Boost/MAP): #3742
Exhaust Clamp: #3728
Inductive Clamp: #3727
HBX-1: Heat-sinking Bung Extender: #3729
XD-1: Digital Display with Remote Record Control: #3743
Power Cable w/ battery Clips: #3734
Replacement Parts:
Analog Output Cable: #3730
Power Cable w/ Cigarette-lighter adapter: #3740
Bung/Plug set: #3735
Sensor (Bosch LSU4.2): #3737
Sensor Cable: #3738
Serial
Cable:
#3741
Order parts, get support, find FAQ answers, and read case
studies at www.tuneyourengine.com
Warning!
1) The Oxygen Sensor used in this device gets very hot in
operation. Do not touch the hot sensor. Do not let a hot sensor
touch a combustible surface. Do not use the sensor with or near
flammable liquids or gases. Failure to heed these warnings may
result in severe burns, explosions or fires. 2) When installed in
the exhaust, the oxygen sensor MUST be connected and
operating with the LM-1 whenever the car is running. An un-
powered oxygen sensor will be quickly damaged when exposed
to hot exhaust gases.
< (10-2303.B)
LM-1 QUICK START GUIDE
The complete instruction manual is on the CD
Warning!
1) The Oxygen Sensor used in this device gets very hot in operation. Do not touch the
hot sensor or let a hot sensor touch a combustible surface. 2) When installed in the
exhaust, the oxygen sensor MUST be connected and operating with the LM-1
whenever the car is running. An un-powered oxygen sensor will be quickly damaged.