Airlink101 AR660W3G - Manual (Page 50)

51
Delete Selected If you want to delete a setting, check the ‘select’ box of the
setting you want to delete, then click ‘Delete Selected’ button.
(You can select more than one setting).
Delete
All If you want to delete all settings listed here, please click ‘Delete
All’ button.
Reset
You can also click ‘Reset’ button to unselect all.
After you finish with all settings, please click “Apply” button.
If you want to reset all settings in this page, please click “Cancel” button.
After you clicked Apply, the following message will be displayed on your web browser:
You can click “Continue” to back to previous setup page to continue on other setup procedures,
or click “Apply” to reboot the router so the settings will take effect (Please wait for about 30
seconds while router is rebooting).
3.3.3 DMZ
If you have a local client PC that cannot run an Internet application (e.g. Games) properly from
behind the NAT firewall, then you can open the client up to unrestricted two-way Internet access
by defining a DMZ Host. The DMZ function allows you to re-direct all packets going to your
WAN port IP address to a particular IP address in your LAN.