ATEN PN9108U - Manual (Page 20)

3. Station ID LED
M The PN9108U’s Station ID usually displays here. If this is a Single
Station installation (see p. 12), or the First Station on a Daisy Chained
installation (see p. 14), the PN9108U has a Station ID of 01.
M The current status (in amps) displays here (instead of the Station ID)
when the Current Display Switch is toggled ON (see item 7, below).
4. 10/100 Mbps Data LED
M The LED lights ORANGE to indicate 10 Mbps data transmission
speed.
M The LED lights GREEN to indicate 100 Mbps data transmission speed.
5. Power LED
Lights when the PN9108U is powered up and ready to operate.
6. Power Control Buttons
Each button (A to H), controls the power status of its corresponding AC
output port as follows:
M Pressing the button for less than 3 seconds toggles the port between
Remote Access enabled and Remote Access disabled (Local Mode). If
Remote Access is disabled, the switch does not allow the port to be
managed from a remote connection.
M Under Local Mode, pressing and holding the button in for more than 3
seconds switches the power to its corresponding port On or Off.
7. Current Display Switch
Toggles between showing the Station ID and current status (in amps) on
the Station ID LED.
8. Reset Switch
Pressing and holding this switch in for more than three seconds resets the
PN9108U to its factory default settings. This switch is recessed and must be
pushed with a thin object, such as the end of a paper clip, or a ballpoint pen.
9. Link LED
Lights GREEN to indicate that a connection via the PN9108U’s RJ-45 Ethernet
port has been established. Flashes to indicate that data is being transmitted.
2005-09-07
PN9108U User Manual
6