Advantech AIMB-766 - Manual (Page 30)

AIMB-766 User Manual 18
2.1 Introduction
You can access most of the connectors from the top of the board as it is being
installed in the chassis. If you have a number of cards installed, you may need to par-
tially remove a card to make all the connections.
2.2 Primary (IDE1) IDE Connector
You can attach up to one IDE (Integrated Drive Electronics) drive to the AIMB-766’s
built-in controller.
Wire number 1 on the cable is red or blue and the other wires are gray. Connect one
end to connector IDE1 on the motherboard. Make sure that the red/blue wire corre-
sponds to pin 1 on the connector (in the upper right hand corner).
Connect the hard drive to the other end of the cable. Wire 1 on the cable should also
connect to pin 1 on the hard drive connector, which is labeled on the drive circuit
board. Check the documentation that came with the drive for more information.