Aiwa NSX-AJ50 - Manual (Page 17)

En
ENGLISH
17
RECORDING
PROGRAMMED EDIT RECORDING
In the programmed edit recording function the tracks can be
programmed while checking the remaining time on each side of
the tape.
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded on from the beginning of
either side.
1 Insert the tape into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
2 Press CD and load the disc(s).
3 Press CD EDIT/CHECK twice.
When using the remote control, press CD EDIT/CHECK twice
while pressing SHIFT.
“EDIT” and “PRGM” are displayed.
• When “AI” is displayed, press CD EDIT/CHECK again.
4 Press numbered buttons on the remote control
to designate the tape length.
10 to 99 minutes can be specified.
•
f , g or MULTI JOG are also available to designate
the tape length.
5 Press DISC DIRECT PLAY 1-3 to select a disc.
Then, press numbered buttons 0-9 and +10 on
the remote control to program a track.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY 2, then press +10 and 0.
6 Repeat step 5 for the rest of the tracks for side
A.
A track whose playing time is longer than the remaining time
cannot be programmed.
7 Press CD EDIT/CHECK to select side B and
program the tracks for side B.
After confirming “B” on the display, repeat step 5.
8 Press CD EDIT/CHECK to select side A and press
w REC/REC MUTE to start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When the last track programmed for side A is finished,
deck 2 enters the recording stop mode. After entering the
recording stop mode, go to step 9.
9 Press CD EDIT/CHECK for recording of the
second side.
“B” is displayed.
10 Turn over the tape in deck 2 and press w REC/
REC MUTE to start recording.
Recording starts.
To stop recording
Press s . Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK to select side A or B,
and press
f or g repeatedly.
To change the program of each side
Press CD EDIT/CHECK to select side A or B, and press s
CLEAR to clear the program on the selected side. Then program
tracks again.
To clear the edit program
Press s CLEAR twice so that “EDIT” disappears on the display.
• Up to 30 tracks can be programmed from any of the inserted
discs.
• “FULL” is displayed if you attempt to program more than 30
tracks.
Maximum recording
time for side A
Tape side A (front side) Tape length
Remaining time
on side A Programmed
tracks
Selected track number
Program number
Tape side B (reverse side)
Program number
Programmed track
numbers
Tape side
Disc number Track number