DataComm 70-0022 1X6 Coaxial 4X6 Phone Module with 4 Port Passive Data - Manual

3/14/08 Rev. 1
Instruction / Installation Sheet
DataComm Electronics 1x6 Coax 4x6 Phone 4 Data Module 70-0022
 Align the mounting pins with holes in the back of the HCC panel and lock
module into place.
Step 1 Video
 Attach a female F-connector onto the cable TV service or satellite service
incoming cable.
 Screw the incoming cable with F-connector to the connector marked
“input.”
 Using F-connectors, terminate all coaxial leads that have been pulled
through the top knockout to the video splitter.
 Align the four mounting pins with holes in the back of the panel (upper
most position recommended) and snap into place.

Step 2 Telephone
 Pull the telephone wires into the HCC panel from one of the side
knockouts.
 Install the cable from the telephone company demarcation point to the
110 IDC marked from Telco.
 Install the twisted pair cables from each location in the house to the
remaining 110 IDC connectors. Match the color-coding of the wires to the
colors on the 110 IDC connectors.
 The wires should be punched down, using an industry standard punch-
down tool, to the 110 IDC connectors following the T568A wiring
configuration as shown below.
 Line 1 is Blue, Line 2 is Orange, Line 3 is Green and Line 4 is Brown.
 A RJ31X port is provided for line 1 seizure by security system.
White / Blue
Blue
White / Orange
Orange
White / Green
Green
White / Brown
Brown
INSTRUCTIONS ARE CONTINUED ON THE BACK SIDE OF THIS PAGE
DataComm Electronics, Inc.
6349 Peachtree St.
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.datacommelectronics.com