IEI Integration AFL-15A-N270 v2.20 - Manual (Page 94)

AFOLUX AFL-15A-N270 Panel PC
Page 94
Remote Access [Disabled]
Use the Remote Access option to enable or disable access to the remote functionalities
of the system.
Disabled D EFAULT
Remote access is disabled.
Enabled Remote access configuration options shown below
appear:
Serial Port Number
Serial Port Mode
Redirection after BIOS POST
Terminal Type
These configuration options are discussed below.
Serial Port Number [COM1]
Use the Serial Port Number option allows to select the serial port used for remote
access.
COM1 D EFAULT
System is remotely accessed through COM1
COM3 System is remotely accessed through COM3
COM4
System is remotely accessed through COM4
NOTE : Make sure the selected COM port is enabled through the Super I/O configuration
menu.
Base Address, IRQ [3F8h,4]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.