IEI Integration AFL-15A-N270 v2.20 - Manual (Page 42)

AFOLUX AFL-15A-N270 Panel PC
Page 42
standby mode. Remote power control is perfect for advertising applications since the
broadcasting time for each panel PC can be set individually and controlled remotely. Other
possible application includes
Security surveillance
Point-of-Sale (POS)
Advertising terminal
4.9 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
The following jumpers can be found on the motherboard installed in the AFL-15A-N270.
Before the AFL-15A-N270 is installed, the jumpers must be set in accordance with the
desired configuration. The jumpers on the AFL-15A-N270 motherboard are listed in Table
4-1 .
Description Label Type
CF card setup JCF1 2-pin header
Clear CMOS J_COMS1 3-pin header
COM1 Pin 9 setting JP6 6-pin header
COM3 Pin 9 setting JP7 6-pin header
COM3 RX RS-232/422/485 select JP8 8-pin header